![]() ![]() ![]() I can then connect the two RJ45 blocks via a cable. I also want to display a RJ45 symbol at the drive that will be a sibling of the ethernet switch and carry port number information. As part of the connection drawing I want to show the IP data (RATING10, 11 &12 ) from the drive at the ethernet switch in the form of a RJ45 symbol. Now that the drive setup is ready I need to show the connection to the ethernet switch. The Hdr2_Enet block then obtains the RATING10, 11 &12 information from the parent. I also have a Hdr2_Enet that is the ethernet module that is plugged into the drive. I then use a Hdr2_XXX to be the control connections for the drive. ![]() This block is loaded with RATING10, 11 &12 that represent the ethernet address, subnet and gateway. Currently I use a block Hdr1_power that is used in the 3 phase part of the drawing. I am looking at taking the connections a step further. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |